Benjamin Franklin Plumbing

Replace Your Water Heater With Benjamin Franklin Plumbing of Niceville, FL

Is Your Hot Water Adequate?

Since water heating is a thermodynamic process using an energy source to heat water above its initial temperature and comprised of parts that can fail, maintaining its hot water production is crucial to your home needs. Typical domestic uses of hot water are for cooking, cleaning, bathing, and space heating.

Commercial applications include both hot water and heated water to generate steam. Water heaters, boilers, and heat exchangers are the mechanical processes used to heat water for a variety of domestic and commercial uses. Water heaters come in two basic forms: tanks and tankless. Some of the more popular domestic water heaters are:

Conventional Tank Water Heaters

Most water heaters are tank water heaters which keep a cylindrical tank full of hot water in your home at all times. The typical sizes available for household water heaters that utilize a tank are between 20 and 100 gallons. When hot water is required, water is circulated to the open faucet. Conventional tanks utilize electric, natural gas, propane, oil, or geothermal power as an energy source to heat the water.

Electric Water Heaters

The typical electric water heater is wired to a 220-volt circuit. To heat the water, the current passes through electrical-resistance heating elements – usually two, one at the middle of the tank and one at the bottom.

Power is delivered to each element through a thermostat – a switch that senses the water temperature. When the temperature drops, the switch closes to allow current flow, and it opens when the temperature reaches its preset limit. Thermostats have a dial for setting the maximum water temperature–generally between 130 degrees and 140 degrees F, or as low as about 120 degrees F for increased energy savings and scald protection.

When a hot water tap is opened, cold water enters the tank through the dip tube and the drop in temperature triggers the thermostat and element at the bottom. As cold water replaces the water at the top of the tank, the temperature at the top thermostat drops and its element kicks in. When the tap is turned off, the heating elements continue to carry current until the thermostats are satisfied.

Gas-Fired Water Heaters

An alternative to electric water heaters is gas-fired, usually utilizing natural gas or propane. Instead of electrical-resistance elements, gas-fired heaters have a burner that’s fed gas through a control valve and a thermostat switch. The burner is usually situated to throw a flame under the tank. The exhaust gases are vented either through a hollow core at the center of the tank or around the tank sides. Because gas-fired heaters heat the tank, which in turn heats the water, there will be more wear and tear on the tank than with electric heat. A gas-fired heater, therefore, may have a shorter life expectancy than an electric heater.

Tankless

A tankless water heater, also called instantaneous, only provides hot water as needed, saving energy and, therefore, saving you money. They are designed to heat water directly without the use of a tank and are more efficient than conventional water heaters. The primary energy sources for tankless heaters are natural gas and propane. Tankless heaters are typically more efficient than storage water heaters. The absence of a tank saves energy as conventional water heaters have to reheat the water in the tank as it cools off, called standby loss.

With a central water heater of any type, water is wasted waiting for water to heat up because of the cold water in the pipes between the faucet and the water heater. This water waste can be avoided if a re-circulating pump is installed, but at the cost of electricity to run the pump and wasted energy to heat the water circulation through the pipes.

Hot Water Circulating Pump

Hot water circulating pumps are often used to circulate domestic hot water so that a faucet will provide hot water constantly upon demand. Since water is piped from the water heater through the pipes to the tap, once the tap is shut off, the water remaining in the pipes cools, producing the familiar wait for hot water the next time the tap is opened. A circulator pump ensures the hot water in the pipes is always hot, minimizing the wait.

Federal Tax Credits

Tankless water heaters with at least an input of over 50,000 BTU/hour and up to 200,000 BTU/hour with a rated storage volume of 2 gallons or less and an energy factor of .82 or greater are eligible for a credit of up to 30% of the cost, not to exceed $1,500.

More information on currently available tax credits for energy-efficient installations can be found on the www.energystar.gov website. At Benjamin Franklin Plumbing we can help you decide which water heater is best for you, based on your Niceville, Fort Walton Beach, Gulf Breeze, Panama City, FL or surrounding area home’s needs and location.